Emptying The Dust Container; Cleaning The Filters - Eureka 910 Serie Guide Du Propriétaire

Aspirateur-traîneau
Table des Matières

Publicité

9
11
8
All manuals and user guides at all-guides.com
1
B
3
A
*
5
7
10
ENGLISH
Caution: Unplug from electrical
!
outlet before servicing.
MAINTENANCE

EMPTYING THE DUST CONTAINER

2
Note: Never operate the cleaner without the dust container
or filters installed. Empty dust cup after each use.
1 Remove the dust container from the cleaner.
2 Remove the filter set from the dust container.
3 Empty the Dust container into the trash.
4 Put the filter set back into the dust container.
1 Put the dust container back into the cleaner.

CLEANING THE FILTERS

4
• Filters should be cleaned or replaced when they become
visibly soiled or suction power is reduced.
• Always operate the cleaner with filters installed to avoid
motor damage.
• Empty the cup and clean or replace the filters if the
Clogged filter indicator changes into red when the
cleaner is operating at maximum power and the nozzle is
raised from the floor.
Cleaning the cartridge filter Style DCF 22
Always operate the cleaner with the cartridge filter installed.
6
4 Remove the cartridge filter by turning it counter - clock -
wise (A) and pull it out (B).
5 Remove the filter screen.
6 Shake debris from filter into the trash.
7 If necessary, rinse filter under tap water.
8 Air dry to ensure it is completely dry before reusing.
5 Replace the filter screen.
2 Insert the cartridge filter into its place (B) and turn it
clockwise (A).
1 Put the filter set back into the dust container.
8
Replacing the HEPA exhaust filter Style HF 12
9 Open the filter grill to remove the exhaust filter.
10 Take the filter out of the grill.
10 Put new filter back into the grill.
9 Close the filter grill.
Blocked air flow and dirty filters
• The cleaner stops automatically if a blockage occurs in
the nozzle/wand/hose or if the filters are blocked with
dirt.
• Disconnect from electrical outlet and allow to cool for 30
minutes.
11 Check for blockage in dirt inlet. Remove cup and remove
blockage from inlet between cup and hose inlet.
• Clean or replace filters. Restart cleaner.
* Depending on the model

Publicité

Table des Matières
loading

Table des Matières