Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
TECHNICAL FEATURES
Power supply
Current consumption @ 12Vcc
Microwave frequency
Alarm, masking contacts
Motion detection coverage
Alarm time
Antimasking
Signal LEDs
Enclosure degree of protection
Environmental classification
Security grading
Operating temperature
External dimensions
Weight (g)
Casing
NOTICES
Once the detector has been powered, wait 3-4 minutes before running the coverage test (the IR sensors need to be stabilised).
In order to obtain a real simulation, free the protected area, preventing more people from moving inside the same area. After 30-40
seconds of quiet, try to access the detection area by moving perpendicularly to the beams, thus avoiding a frontal approach.
Check the operation of the two PIRs with the two green LEDs and the operation of the microwave with the yellow LED. Run the
operation test, making sure to break the IR beams (see fig.1) by moving perpendicularly to them.
Once detection has been achieved, wait for at least 7-8 seconds before trying to be detected again.
The covered area pattern is shown in fig.1.
SELECTING THE COVERAGE AREA
The maximum detection range is 3 ~ 12 meters per side (2 sides), (at 120 cm from the ground) with covered area of about 5°, (25
° C, 75% relative humidity). Particular conditions may increase or decrease the detection range.
The detector can work both in AND or in OR configuration for PIRs.
The possible configurations are described in the paragraph of setting out the DIP switch and relative examples of installation
16
3. TECHNICAL SPECIFICATIONS
SHIELD V
from 9 to 15 Vcc
20 mA (max.)
K Band 24GHz
MOS FET relay 100 mA 35 V, 2 Ω max.
3 ~ 12 meters each side (2 sides)
1 s
Active IR
4
IP44
Class IV (EN 50131-I)
Grade 3 (EN 50131-I)
-25 °C / +55 °C
81x56x189 mm
470
UV resistant polycarbonate
Publicité
Table des Matières
