Dexter 1300CIS2-185.5 Manuel D'instructions page 166

2. General Safety Rules
secure before making a cut. If blade adjustment shifts while cutting, it may cause
binding and kickback.
Use extra caution when making a "plunge cut" into existing walls or
g)
other blind areas. The protruding blade may cut objects that can cause kickback.
8) Safety instructions regarding lower guard
Check lower guard for proper closing before each use. Do not operate
a)
the saw if the lower guard does not move freely and close instantly. Never
clamp or tie the lower guard in the open position. If the saw is accidentally
dropped, lower guard may be bent. Raise the lower guard with the blade guard
lever and make sure it moves freely and does not touch the blade or any other part,
in all angles and depths of cut.
Check the operation of the lower guard spring. If the guard and the
b)
spring are not operating properly, they must be serviced before use. Lower
guard may operate sluggishly due to damaged parts, gummy deposits, or a
build-up of debris
c) Lower guard should be retracted manually only for special cuts such as
"plunge cuts" and "compound cuts". Raise lower guard by blade guard
lever. As soon as blade enters the material, the lower guard must be
released. For all other sawing tasks, the lower guard should operate automatically.
Always observe that the lower guard is covering the blade before
d)
placing the saw down on bench or oor. An unprotected, coasting blade will
cause the saw to walk backward, cutting whatever is in its path. Be aware of the
time it takes for the blade to stop after the switch is released.
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate
all residual risk factors. The following hazards may arise in connection with the
power tool's construction and design:
Damage to lungs if an e ective dust mask is not worn.
Damage to hearing if e ective hearing protection is not worn.
Damages to health resulting from vibration emission if the power tool is being
used over longer period of time or not adequately managed and properly main-
tained.
166
FR
ES
PT
IT
PL
UA
RO
GR
EN