Dexter 1300CIS2-185.5 Manuel D'instructions page 172

7. Maintenance
Do not use cleaning agents to clean the plastic parts of the tool.
A mild detergent on a damp cloth is recommended.
Please read "WARNING" or previous section regarding checking and
changing of the SAW BLADE.
1. Replace the saw blade according to which material to cut, as soon as its teeth
are blunt and proper sawing is therefore no longer possible.
2.Clean the appliance after completing your sawing work.
3. Remove any dirt (e.g. sawdust). If necessary, clean the saw blade mounting
with a brush or blow it out with compressed air.
8.Trouble shooting
Problem
Product does not start
Product does not reach
full power
Unsatisfactory result
Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the
product
Carbun brush
Extension cord not suitable for
operation with this product
Power source(e.g.generator)has
too low voltage
Air vents are blocked
Blade is worn
172
Solution
Connect to power supply
Check by a specialist
electrician
Check by a specialist
electrician
replaced in pairs
Use a proper extension
cord
Connect to another power
source
Clean the air vents
Replace with new blade
FR
ES
PT
IT
PL
UA
RO
GR
EN