Popping Instructions - Klarstein VOLCANO Manuel

EN
14
3
Insert the removable tray.

POPPING INSTRUCTIONS

Assembly procedure
• Make sure the popcorn maker is unplugged before you do any of the following.
• Before using the unit, please check carefully to be sure voltage (220-240 V
~50/60 Hz) is suitable for
your home.
• Clean the internal surface of the kettle with warm soapy water, rinse well and dry
with clean cloth.
Wipe down inner and outer housing with damp cloth.
Operation
1. Main unit has a 2-function switch as follows:
- LIGHT: to turn light on;
- POP: to turn motor & heater on.
2. Insert the internal plug into the socket.
3. Plug the power cord into an electric outlet.
4. Switch on LIGHT & POP. The light, motor and heater will turn on. Allow the boiler to
preheat for 2-3 minutes..
5. Turn the POP switch to off position.
6. Lift lid up using the lid tab to pour ingredients into the kettle. Add 1 tablespoon
vegetable oil. Then quickly add 1/3 cup of popcorn corn (1/3 measuring cup
included). Close the lid. Switch POP on again, the motor will move and the kettle
will be heated.
CAUTION: Lid might be hot – it is recommended to use an oven mitt.
4
Place the door on hinges.