Using The Combination Mode; Using The Rotary Spit - Bosch HSG738155M Notice D'utilisation Et De Montage

Using the combination mode

Only model HSG738155M and HSG736155M:
Note the following points when using combination mode:
Note: Never use combination mode for longer than 40 minutes
to ensure that the appliance does not overheat and cause
material damage to the coating.
The temperature range marked on the control knob for the
■
oven only applies to conventional heating. When the
combination mode is used, the temperature in the oven is
higher than the temperature which was set on the control
knob.
If you are operating the grill gas burner at the lowest flame
■
setting, you must also set the lowest temperature for the oven
gas burner.
Switching on combination mode
Open the appliance door.
1.
Switch on the oven gas burner by pressing the control knob
2.
for the oven and turning it anti-clockwise to the required
temperature (on the control knob between "Min" and 275).
The gas burner ignites.
Press and hold the control knob for a few seconds until the
flame stabilises.
Carefully close the appliance door.
3.
4. Keep the appliance door closed. After 15 minutes, switch on
the grill gas burner by pressing the control knob for the grill
and turning it anti-clockwise to position
The gas burner ignites.
Press and hold the control knob for a few seconds until the
flame stabilises.
5. After 10 minutes, open the appliance door carefully and
place the meal inside.
Carefully close the appliance door.
6.
7. Use the control knob to set the desired temperature and heat
setting for both burners.
Switch on the grill when the oven gas burner is already in
operation
When using conventional heating, you can briefly turn on the
grill at the end of the cooking time for food and baked goods
which require more intense browning or a crisped finish (e.g.
crackling).
Turn the control knob for the oven to the minimum position
1.
"Min".
Keep the appliance door closed. Switch on the grill gas
2.
burner by pressing the control knob for the grill and turning it
anti-clockwise to position
The gas burner ignites.
Press and hold the control knob for a few seconds until the
flame stabilises.
After 10 minutes, set to the required temperature.
3.
Switch on the oven when the grill gas burner is already in
operation
Keep the appliance door closed. Switch on the oven gas
1.
burner by pressing the control knob for the oven and turning
it anti-clockwise to maximum position 275.
The gas burner ignites.
Press and hold the control knob for a few seconds until the
flame stabilises.
Immediately after igniting, turn the control knob for the oven
2.
to the minimum position "Min".
3. After 10 minutes, set to the required temperature.
Switching off combination mode
Turn off the grill and oven gas burners.
All manuals and user guides at all-guides.com
—
.
—
.

Using the rotary spit

The rotary spit can be used to cook joints such as rolled joints
and poultry with excellent results. The meat is roasted
thoroughly and evenly.
Use the rotary spit in conjunction with the grill or combination
mode.
Preparing joints
Place the joint as centrally as possible on the rotary spit and
secure it at both ends with the retaining clips.
You can also truss the joint with string. With poultry, bind the
ends of the wings underneath the back and the thighs against
the body. This prevents them from overbrowning.
Pierce the skin on the underside of the wings to allow the fat to
escape.
: Inserting the rotary spit
Risk of scalding!
The accessible parts become hot during operation. Never
touch the hot parts. Keep children at a safe distance.
Insert the rotary spit as follows:
1. Slide the rotary spit shelf halfway in at shelf position 2.
2. Place the rotary spit on the rotary spit shelf and unscrew and
remove the handle.
Slide the rotary spit shelf in all the way and slide the rotary
3.
spit to the left into the motor mount.
Add some water to a baking tray and slide it in at shelf
4.
position 1 as a container to catch the dripping fat.
Close the appliance door.
5.
Operating the rotary spit
Switching on the rotary spit
Turn the control knob for the rotary spit clockwise to position
F
.
Switching off the rotary spit
Turn the control knob for the rotary spit anti-clockwise to Û
position .
13