Initial Start-Up; Setting Up The Charging Station; Charge Battery - Heiniger Opal Notice Originale

6 Operation
WARNING!
Incorrect operation may cause damage on persons or objects. Therefore:
y Do all the steps of operation according to the indications in this instruction
manual.
6.1

Initial start-up

6.1.1

Setting up the charging station

y Observe all technical data according to the operating conditions (3 Tech-
nical Data).
y The installation surface must be even and must dispose of sufficient stabi-
lity and payload.
y The location of installation must be protected against humidity and rain.
y Power outlets in the outer area must be equipped with a residual current
circuit breaker (FI).
y The workplace must dispose of sufficient illumination and ventilation.
y The location of installation must be out of reach of children.
Fig. 12
3. Place the clipper, with the battery inserted, in the charging station so that
the upper part of the clipper is facing towards you and the contacts on the
clipper are resting against the contacts of the charging station. The part
with the switch is the upper part of the clipper (Fig. 12).
4. During the charging process the LED indicator lamp stays lit red continuo-
usly. Once the charging process is complete the LED indicator lamp stays
lit green continuously. and the clipper is ready to use. This charging station
has an LED indicator lamp.
6.1.2

Charge battery

1
Fig. 13
12
1. Place the charging station on a firm,
even, dry, clean and free underground.
2. Plug the charging station in the power
outlet.
1. Test the contacts of the clipper (1) and
the battery (2) for foreign particles and
2
contamination.
2. Assure, that the switch lever of the clip-
per is in OFF-position ("0") (fig. 4).
Translation of the original instructions / Small animal clipper