Télécharger Imprimer la page

Publicité

Liens rapides

Reflexion 48"
Reflexion 60"
Reflexion Side panel 32"
Reflexion Side panel 36"
ZITTACLEAN
Le micro film protecteur formé lors de
son application,fera perler l'eau sur le
verre afin d'en faciliter l'entretien.
The micro protective layer formed during
its application will make the water bead
along the glass for easy maintenance.
L'ENTRETIEN DE VOTRE DOUCHE
Ne jamais utiliser de poudre ou de
tampon à récurer .Il suffit de nettoyer
la porte avec une solution d'eau et
vinaigre, 1 pour 5.Vous pouvez utiliser
un détergent doux, mais aucun produit
à base d'ammoniaque cela pourrait
endommager la surface de la vitre.
THE MAINTENANCE OF YOUR
SHOWER
Never use of powder or scouring pads.
Simply clean the door with a solution of
water and vinegar,1 to 5.You can use a
mild detergent but never use ammoniac,
it could dammage the glass surface.
La porte doit être du même côté que le
panneau de retour.
The door must be the same side as
the side pannel.
Les instructions montrés au manuel sont
pour le montage de la porte droite.
The instructions shown in the manual
is for the installation of the right door.
Vous rendre sur notre site internet le www.zitta.ca pour la dernière mise à jour de ce
document et voir un vidéo sur la procédure d'installation du produit .Vidéo, pas
disponible pour tous les produits.
Visit our website at
www.zitta.ca
about the installation procedure. Video not available for all products.
Dessin porte à droite.
Drawing right door.
Thoroughly inspect your product before proceeding with the installation.
The warranty will be void if the product is installed with a conspicuous defect.
To prevent leaks, silicone must beapplied on the outside of the shower and not on the inside!
Read all instructions carefully before starting the installation.
Save this manual for future reference.
for the last update of this document and see a video
Disponible pour installation du
côté droit ou du côté gauche.
Available for installation on the
right side or the left side.
Update:20131028

Publicité

loading

Sommaire des Matières pour Zitta Reflexion 48

  • Page 1 Update:20131028 Vous rendre sur notre site internet le www.zitta.ca pour la dernière mise à jour de ce document et voir un vidéo sur la procédure d’installation du produit .Vidéo, pas disponible pour tous les produits. Visit our website at www.zitta.ca for the last update of this document and see a video about the installation procedure.
  • Page 2 Qté Qté Numèro Description Numèro Description 48"Code 60"Code 48"Code 60"Code Description Description Couvert d’extrusion mural Chrome Joint pour porte 10mm PQ000102 PQ000102 PJ002310 PJ002310 Channel cap extrusion Gasket for door 10mm Ancrage chrome mural pour bar de roulement Extrusion mural d’aimant chrome 10 mm PQ006702 PQ006702 PA000302 PA000302 Chrome Wall bracket for rolling bar...
  • Page 3 Squeeze gasket Wall anchor s 1 5/8" tête pan / 1 5/8" Pan head screw PV000299 Reflectino miroir/Reflection mirror PG005230 Reflectino miroir/Reflection mirror PG005330 Aimant 90/Magnet 90 degre PJ002510 Ancrage chrome de vitre p Glass chrome bracket for gla PQ007702 PQ000302 PT00019...
  • Page 5: Important

    Vous référez au manuel d’instruction pour I’installation des bases. Forbaseinstallationrefertobaseinstallationmanual 48"(45 1/2"~46 3/8") (1155mm~1178mm) 60"(57 1/2"~58 3/8") (1460mm~1483mm) 3/4" to 1/3/16" 19mm- 30mm Vérifier les dimensions Verify the dimensions 1/4" à 1/2" 1/4" à 1/2" 6mm à 13mm 6mm à 13mm Inverser les instructions pour la porte coulissante à...
  • Page 6: Couper Au Besoin Cut If Needed

    INTERIEUR INTERIEUR IMPORTANT INSIDE INSIDE MIN1/2" 13mm Sp10 1/8" Côté gauche Côté droite Left side Right side Couper au besoin Cut if needed...
  • Page 7 " " " " IMPORTANT:Les dimensions sont " approximatives.installer la barre de roulement de chrome au niveau afin de valider le positionnement au mur. " IMPORTANT:The dimensions are approximate. The installation of the rolling bar should be at the level to validate is position on the wall. IMPORTANT...
  • Page 8 SUITE / CONTINUED INSTALLER PORTE Install door...
  • Page 9 Couper au besoin Cut if needed 2" 52mm EXTÉRIEUR INTÉRIEUR OUTSIDE INSIDE...
  • Page 10 Intérieur Inside Extérieur Outside Si les aimants de sont pas enligner verticalement; En haut: bouger l’attache Sp8 vers l’intérieur ou l’extérieur. En bas: installer item 30(support d’installation pour vitre) sous la vitre du panneau de côté en avant ou en arrière. If the magnet are not line up vertically: At the top, move the attached Sp8 Towards the inside or exterior At the bottom: install item 30-(installation bracket for glass)
  • Page 11 Pour I’installation de la base,consulter le manuel d’installation de base Forbaseinstallationrefertobaseinstallationmanual (45 1/2"~46 3/8") (1155mm~1178mm) (57 1/2"~58 3/8") (1460mm~1483mm) 1/4"-3/4" 6mm-19mm 1/4"-3/4" 6mm-19mm Inverser les instructions pour la porte coulissante à gauche. Reverse the instructions for the sliding door left. 1/4 "...
  • Page 12 IMPORTANT INTERIEUR INTERIEUR INSIDE INSIDE MIN1/2" 13mm INTERIEUR INTERIEUR INSIDE INSIDE 1/8" Côté gauche Côté droite Left side Right side Couper au besoin Cut if necessary...
  • Page 13 " " " " IMPORTANT:Les dimensions sont " approximatives.installer la barre de roulement de chrome au niveau afin de valider le positionnement au mur. " IMPORTANT:The dimensions are approximate. The installation of the rolling bar should be at the level to validate is position on the wall. IMPORTANT...
  • Page 14 SUITE / CONTINUED INSTALLER PORTE Install door...
  • Page 15 IMPORTANT 1/4" IMPORTANT SILICONE SILICONE...
  • Page 16 EXTÉRIEUR INTÉRIEUR OUTSIDE INSIDE SILICONE...
  • Page 17 Extérieur Intérieur Outside Inside...

Ce manuel est également adapté pour:

Reflexion 60