Geberit ESG 40/200 Mode D'emploi page 20

All manuals and user guides at all-guides.com
Operating instructions ESG 40/200
Troubleshooting
If the or
process has been prematurely aborted due to a malfunction.
Disconnect the mains plug so that the trouble indication goes out and the
malfunction can be corrected.
Error Cause
and Malfunction of the
light up mains voltage
(undervoltage)
Malfunction of the
mains voltage
(overvoltage)
and Malfunction on the
light up sleeve during
welding
and Device
light up temperature is too
high
and Ambient
light up temperature is too
low
, and Fault current has
light up been activated
lights up Malfunction inside
the device
20
indicator and an additional indicator light up, the welding
Actions
• Disconnect other devices from the power
• Use a generator with a higher power
• Connect additional consumers to the mains /
• Check the contacts of the sleeve connection
• Use a new sleeve
• Increase the waiting time between welding
• Set the device up in a location with better
• Do not expose the device, the electrofusion
• Set the device up in a warmer location
• Check all contacts for signs of moisture or
• Return the device to the Geberit service centre
inaktiv / inactive
supply system
generator
cable
processes
ventilation
sleeve coupling or the electrofusion tape to
direct sunlight
foreign material and dry or remove if necessary