Door Reversibility - Electrolux TG1000N Notice D'utilisation

58 www.electrolux.com
9.3 Location

9.4 Door reversibility

All manuals and user guides at all-guides.com
100 mm
15 mm 15 mm
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net.To ensure best performance, if the ap-
pliance is positioned below an overhanging
wall unit, the minimum distance between
the top of the cabinet and the wall unit must
be at least 100 mm . Ideally, however, the
appliance should not be positioned below
overhanging wall units. Accurate levelling is
ensured by one or more adjustable feet at
the base of the cabinet. If the cabinet is
placed in a corner and the side with the
hinges facing the wall, the distance between
the wall and the cabinet must be at least 10
mm to allow the door to open enough so
that the shelves can be removed.
WARNING!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
To carry out the following opera-
tions, we suggest that this be
made with another person that will
keep a firm hold on the doors of
the appliance during the opera-
tions.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power sock-
et.
• Tilt back the appliance carefully so that
the compressor cannot touch the floor.
• Unscrew the left foot.
• Unscrew the screws of the door bottom
hinge.