lamber GS5-ek Instructions D'emploi page 24

CLEANING AND
MAINTENANCE
PRECAUTION AND
INSTRUCTIONS
- IMPORTANT : Before carrying-out the
cleaning and maintenance
disconnect the equipment from the mains
power supply:
- high temperatures can be reached inside
the machine (90°C). After power supply has
been removed, wait until the machine has
reached the room temperature, before
working on it.
- the machine protection degree is IP21,
therefore it should not be washed with
direct high pressure jets of water;
- never leave tools, parts or other loose
material on or in the machine;
- BEFORE starting machine or cycle, after
any maintenance or repair work, make sure
all protective are correctly installed;
POSSIBLE TROUBLES - CAUSES - SOLUTIONS
PROBLEMS
The machine doesn't catch
The water doesn't go in
Insufficient Washing
Insufficient Rinsing
Lamp "E" will flash
Lamp "E" flash slowly
Lamp "E" flash fastly
Lamp "E" continue flashing
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE
All manuals and user guides at all-guides.com
PREVENTIVE
CLEANING
operations,
CAUSES
Main switch is switched off;
Water cock closed;
The Overflow is not in its place;
Wrong detergent or dosage
insufficient;
Low temperature in the tank;
Dirt wash filter;
Rinsing nozzles blocked;
Hydraulic pressure lower than
1 bar - 100 kPa;
Door open;
Drain Off;
Drain pompe doesn't work;
Heater doesn't working;
23
DAY MAINTENANCE
- Let the water drain out of the tank pushing
the button "F";
- Disconnect the machine with pushbutton
"A";
- Wash thoroughly the
housing to remove all impurities;
- Take the filters and clean it under running
water;
- Re-assemble the overflow pipe and the
filters in their housings;
- Check and clean the washing and the
rinsing jets;
- Clean the outer surface of the machine by
using a wet sponge; don't use water jets
because, beside being dangerous they
could damage the electrical parts; don't
use abrasive detergents;
- When the machine is to remain idle for a
long time, drain all the water from
boiler and from the
Also leave the wash tank
NEVER WASH THE EXTERNAL PART
THE MACHINE WITH A WATER JET
SOLUTIONS
Turn ON the main switch;
Open water cock;
Reassemble the Overflow in its
place;
Use anti-foam detergent in the
right dosage and never with
cold water;
Wait untill the water gets hot;
Clean filter;
Unscrew and clean nozzles
under running water;
Wait till the pressure is on or buy
a booster pump;
Close the door;
Stop machine;
Call service
Call service
tank and the filter
the
electropump.
open.
OF