Intended Use; Assembly And Operation - Worx WX820 Mode D'emploi

185*95mm
Finishing 3
sanding paper
125mm
Random orbit
3
H&L
sanding paper
140*90mm
Detail H&L 3
sanding paper
76*30mm
Finger H&L 3
sanding paper
100*50mm
Contour H&L 3
sanding paper
We recommend that you purchase your accessories from
the same store that sold you the tool. Refer to the accessory
packaging for further details. Store personnel can assist you
and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE:

This machine is intended for dry sanding of wood,
plastic, filler and coated surfaces. The sander is not to
be used for plaster or spackle.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Fitting &Replacing the Sanding Plate
Note: Read and understand the instructions
before assembling or changing sanding plates.
Note: Open the Hyperlock lever completely
when attaching or removing a sanding plate.
Note: When assembling the finishing plate/
detail plate, first check the assembling direction.
WARNING!The sanding plate must
be attached before starting the
sander.
WARNING! Avoid pinching hands
and fingers when using the
hyperlock™.
WARNING! Do not touch the
bottom fan after use to avoid
high-temperature burns.
5-in-1 Multi Sander
3 3
3 3
3 3
3 3
3 3
FIGURE
See Fig.
A1-A8
WORKING HINTS FOR YOUR
MULTI SANDER
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speed. Always
use sand paper that is suitable for the material you
Fitting the Sanding Paper
Attaching the Dust Bag
Caution:
To prevent the possibility of dust or a
foreign body being thrown into your face or
eyes, never attempt to use your sander without
the dust bag properly installed.
Charging the Battery Pack
Installing the Battery Pack
OPERATION
Switching On/Off
Using the Variable Speed Dial (Speed
settings 1-6)
- The Variable Speed Dial can be used to set the
optimum speed according to the sanding plate
used and the respective application.
Sanding
Application
paper
Sanding down
180...400
varnishes
Sanding paint 40...120
Touching up
120...240
paintwork
Sanding wood 60...240
Machining
180...240
veneer
Derusting metal 40...120
Sanding metal
120...240
and steel
Sanding curved
60...240
surface
Removing the Battery Pack
Emptying the Dust Bag
-For more efficient operation, empty dusts bag
every 5-10 mins.
See Fig.
B1-B6
See Fig. C
See Fig.
D1,D2,D3
See Fig. E
See Fig. F
Speed
3-6
4-6
See Fig. G
1-5
1-6
3-5
4-6
4-6
1-6
See Fig. H
See Fig. I1-I2
EN
13