Kathrein UFO 331/TP Mode D'emploi page 23

When Channel fi lter "on" is selected a "P" appears at the top right corner of the main menu.
*** UFO331TP
Filter
IDs
"Transport stream processor" sub-menu
To process the channel list for the channel fi lter, the current channel table is read from the transponder by selecting the "Filter"
parameter by pressing the "Sub-menu" button
As soon as the channel unit has successfully determined this information, the sub-menu for adjustment is displayed.
If a CI retrofi t kit is fi tted an additional parameter is shown in the second line, see also the next chapter.
*** UFO331TP
T / 001 /
Das Erste
Compile
"Filter" sub-menu
The fi rst line shows the type of the programme that was selected, together with the number of the channel and the number of channels
on the transponder.
T = TV channel
Channel no. (e.g. 001)
of the selected channel
The second line shows the channel name, together with its fi lter status (+ or -).
The default setting for the status of the channels that are displayed is "-", i.e. no channels are transmitted when the channel fi lter is
switched on, but the channel list is not being processed.
The "Compile" button in the third line starts the compilation of the channel list, which then becomes effective.
The selection of the channels carried over is performed using the "+" and "-" buttons, where the status "+" means the channel will be
carried over and the status "-" means it will be removed. The "Status" parameter is selected using the "<" and ">" buttons.
The settings become effective when the fi lter table is compiled. This is done using the "<" and ">" buttons; select the "Generate"
parameter and use the "+" or "-" buttons to initiate the generation of the channel table.
Note: The channel fi lter can be edited even if it is not activated ("OFF"). This means that the operation can be checked
or temporarily deactivated without waiting times or reprogramming.
If the channel list was not processed but the channel fi lter was switched on, the previously saved list will be
active, or in the absence of any list no channels will be transmitted.
*** UFO331TP
T / 001 /
Das Erste
Compile
"Filter" sub-menu
***
off
in the channel fi lter. A progress bar appears while this is done.
***
009
/
R = Radio channel
/ Quantity (e.g. B. 009)
of the channels in the transponder
***
009
/
....
When changing to the "Filter" sub-menu
***
T / 001
-
Das Erste
Compile
D = Data service
-
....
On compiling the channel fi lter
9 / 14
Programme
information
is read in
UFO331TP
/ 009
"Filter" sub-menu
Channel fi lter
being compiled
***
/ -