Kathrein UFO 331/TP Mode D'emploi page 17

"P" Left from "TP":
"P" indicates that the channel fi lter is activated and that some channels may be removed from the transport stream.
If the front end is not clicked into place (no Sat input signal), the following display appears:
A 1236
27.500 MS/s
Outp. S21
8 MHz
Main menu (front end not clicked into place)
The modulation type of the satellite input signal can be seen on the main menu display.
In DVB-S1 operating mode it is always QPSK. Both QPSK and 8PSK are possible in DVB-S2 mode.
A 1236
27.500 MS/s
Outp. S21
8 MHz
Main menu (example for DVB-S1)
1. Confi guration of the channel unit
1.1 Selecting the input socket
The socket A or B to be used for the input can be selected in the main menu for the system.
A 1236
27.500 MS/s
Outp. S21
8 MHz
Main menu
The following settings are available: A or B
1.2 DiSEqC setting
TM
The sub-menu for the DiSEqC
Pressing the "Sub-menu" button
1236
A
27.500 MS/s
Outp. S21
8 MHz
Main menu
MHz * TP
--- ----
306.00 MHz
QAM64
MHz TP
3/4
QPSK
306.00 MHz
QAM64
MHz TP
3/4 QPSK
306.00 MHz
QAM64
controller for a matrix can be set in the input socket that was selected.
TM
activates the sub-menu; pressing the "Sub-menu" button
MHz TP
3/4 QPSK
306.00 MHz
QAM64
!
A
22.000
Outp.
! 8
!
***
DiSEqC
!
3 / 14
2122 MHz
MS/s 2/3
S21 306.00
MHz QAM64
Main menu (example of DVB-S2)
again deactivates it.
UFO331TP
Off
Sub-menu for channel unit I
TP
8PSK
MHz
!
**