Falcon 1000 DF Guide De L'utilisateur page 19

Check that the links are correctly fi tted and that the
terminal screws are tight. Secure the mains cable using
the cable clamp.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30-milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fi tting
a 100mA device. This work should be carried out by a
qualifi ed electrician.
Refit the doors
Refi t all the oven doors to the cooker.
Hotplate
Check each burner in turn. There is a fl ame safety
device that stops the fl ow of gas to the burner if the
fl ame goes out. There is also a spark ignition system
that works when the knob is pressed in.
For each burner, push in and turn the knob to the large
fl ame symbol ( ).
The igniter should spark and light the gas. Keep holding
the knob pressed in to let the gas through to the burner
for few seconds.
If, when you let go of the control knob, the burner goes
out, the safety device has not held in. Turn the control to
the off position and wait one minute, then try again this
time holding in the control knob for slightly longer.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
Turn on the ovens and check that they start to heat up.
Turn off the ovens.
Fitting the plinth
Remove the 2 screws along the front bottom edge of the
cooker. Hold the plinth in place and refi t the 2 screws.
All manuals and user guides at all-guides.com
19
Customer care
Please inform the user how to operate the cooker and
hand over these instructions.
Thank you.
English