Beyerdynamic MCW DIGITAL 200 Notice D'utilisation page 59

3.9 How to record the Meeting
MCW-D 2673
(2)
3.10 Maintenance of the MCW-D Microphone Units
• For cleaning the MCW-D microphone units when they are slightly dirty (finger prints, dust, jam or juice) use a soft, damp cloth,
sponge or brush and a liquid cleaning agent.
• Before cleaning the surface it must be moistened thoroughly. Afterwards it must be cleaned with a damp cloth.
• Make sure not to allow any water to enter the unit.
• For dirt caused by mineral oils and fats, animal and vegetable fats use spirit, isopropyl alcohol or benzine.
• For dirt caused by ballpoint pens, typewriter ribbons or carbon paper use isopropyl alcohol or spirit.
• Clean the charging contacts of the microphone units with spirit or isopropyl alcohol from time to time.
• Clean the supplied pop shield with clear water. Make sure that it is completely dry before you put it on the microphone again.
• For recording the meeting you can connect a recorder to the
documentation output (4).
• The volume can be adjusted with a PC using the MCW-D 200 Editor
software.
• Instead of a recorder it is also possible to connect a headphone to the
documentation output (4). We recommend a min. impedance of 30 Ω.
(4)
• For recording the meeting you can connect a recorder to the terminal
strip 2. The volume can be adjusted with a PC using the MCW-D 200
Editor software.
• Instead of a recorder you can connect a headphone to the terminal
strip 2. We recommend a min. impedance of 30 Ω.
Important:
• If the three pins are not used for the headphone socket, the
pins "TIP+DET" and "DET" have to be bridged, otherwise the
microphone unit could act as if a headphone were connected
and thus receive signals on a wrong channel (LED and illuminated
ring will flash red).
59