Beyerdynamic MCW DIGITAL 200 Notice D'utilisation page 53

Top view MCW-D 2073 chairman microphone unit
(5)
(7)
(9) (10)
(8)
3.2.2 Switching on / off
MCW-D 2071 MCW-D 2073
(7)
(8)
MCW-D 200
(2)
(3)
3.2.3 DC-powered MCW-D 2071 DC and MCW-D 2073 DC Versions
• The MCW-D 2071 DC and MCW-D 2073 DC have no integrated battery, but are DC-powered.
• The power cable is connected in a daisy chain. Connect the first microphone unit with a suitable power supply unit. Connect
the second microphone unit to the first, the third to the second and so on. For a suitable power supply unit please contact your
beyerdynamic representative.
(5) Gooseneck microphone with illuminated ring
(6) Loudspeaker
(6)
(7) LED to indicate the function (green / red)
(8) Microphone button
(9) Clear button for clearing the delegate microphone units
(10) Function button for optional functions (refer also to chapter 4.3)
(11) LC-Display
(12) Buttons for adjustments
(11)
(12)
Switching on
• The microphone units have no separate on/off switch. They are
switched on and off with the microphone button (8).
• By pressing the button briefly, the microphone unit is switched on.
The LED (7) flashes for a moment and the green LED (2) on the rear is
illuminated.
Switching off
• By pressing the button for more than 2 seconds the microphone
(7)
unit is switched off and the LED (7) will illuminate twice orange
briefly.
(8)
• If you press the standby button (2) of the MCW-D 200 control unit for
more than 3 seconds, you switch off all switched-on MCW-D micro-
phone units within the range of the MCW-D 200 control unit.
• Furthermore, the microphone units are switched off automatically,
when they do not receive a signal from the control unit for more than
3 minutes.
Important:
• If the microphone unit is out of range of the MCW-D 200 control
• If the system should fail to operate, i.e. the microphone unit is
unit the LED (7) will flash red. After approx. 3 minutes the
microphone unit will switch off automatically.
switched on but no sound is heard, press the reset button (3)
of the control unit. Should the system still fail to operate,
check the audio configuration with the MCW-D 200 Editor
Software. If the system still does not operate then, please contact
your beyerdynamic representative.
53