Fastening The Infant Carrier Using The; Adjusting The Support Leg - Foppapedretti Base NEXT i-Size Notice D'utilisation

ENGLISH
• •
All manuals and user guides at all-guides.com
USE IN THE CAR
3.1 Fastening the infant carrier using the ISOFIX base
Make sure that your vehicle has ISOFIX anchor points and is approved in the
vehicle application list which is supplied with the base.
Locate the vehicle ISOFIX points. if any problem please consult the vehicle
manual. They are usually between the vehicle seat base and back.
Insert the two plastic ISOFIX guides and hook them onto the vehicle ISOFIX
points.
The plastic guides can help identify the vehicle ISOFIX points and make installation
easier. They can also help with the protection of your vehicle seat. (fig. 1).
Lift up lever (1) and at the same time push (2) the upper joint of the support leg to
the last position, extending the ISOFIX connectors to the longest position. (fig. 2)
Push the base in the direction of the vehicle's ISOFIX anchoring points to attach
the two connectors. You will hear a click once they have attached. Check that the
indicators are green on both sides (fig. 3, 4).
Push the Next i-Size base against the passenger seat until it is completely resting
on the backrest (fig. 4).

3.2 Adjusting the support leg

Press the button to adjust the support foot and lower it down so that it correctly
touches the vehicle floor. The control indicator located at the base of the support
leg must move from the colour orange to green, indicating that the foot has been
placed correctly. Check that the support foot is positioned and adjusted correctly
(fig. 5, 6)
Make sure that the support leg does not raise the base from the surface of the
vehicle seat.
Do not place the front support leg on a floor storage compartment lid. The front
support leg MUST make full and firm contact with the vehicle floor
Make sure that the upper surface of the ISOFIX base is free from foreign bodies.
20