Locking The Infant Carrier; Removal Of The Infant Carrier; Removing The Car Seat; Removal The Isofix Base - Foppapedretti Base NEXT i-Size Notice D'utilisation

ENGLISH
• •
All manuals and user guides at all-guides.com
USE IN THE CAR

3.3 Locking the infant carrier

Make sure that the handle is in a vertical position.
Position the seat on the ISOFIX base so that it is opposite to the direction of travel
(baby facing backwards). Then fasten it (a "CLICK" sound will indicate that it has
been fixed in place (fig. 7, 8).
IMPORTANTE: After attaching the car seat to the base, the control indicator on
the sides of the ISOFIX base must change from the colour orange to green on
both sides to indicate that it is correctly attached (fig. 8).
Lift the car seat to make sure that all four connections have engaged correctly and
the connection indicators have changed from red to green.
4. REMOVAL OF THE INFANT CARRIER AND ISOFIX BASE

4.1 Removing the car seat

Pull the car seat release lever (grey) and at the same time lift up the seat (fig. 9).
Important! When used on a daily basis you can leave the ISOFIX base mounted
on board the car, simply removing the car seat.
4.2 Removing the ISOFIX base
Pull the ISOFIX release buttons, as shown in the figure, to release the connectors
from the vehicle's ISOFIX attachments, and remove the base (fig. 11).
Lift up lever (a) and at the same time pull the upper joint of the support leg
outwards to make the ISOFIX connectors retract inside the base.
5. Maintenance
The plastic parts can be washed with a mild soap and warm water.
21