E-Bike E3000 Mode D'emploi Et D'entretien page 87

charge your bike strictly
according to this
instruction stated in
Chapter 7, to avoid any
trouble and damage
occurred to your bike.
There is no speed/KM
show on the LCD
12. DIAGRAM AND SPECIFICATION.
We reserve the right, without further notice, makes modifications to the product. For further advice, please
contact your vendor.
(Fig 17)
4) the output voltage is too low to
charge the battery.
The magnetic ball point on the wheel
spoke is in too far away distance
from the wheel speed sensor (fixed
to frame chain stay or front fork),
which make the sensor can not get
any signals of the revolving wheel.
discharge;
4) no charging when the power supply is
lower than 100V.
If the above has no effect, please contact
your vendor or authorized service.
Check the distance between the magnetic
ball point and the wheel speed sensor, and
make sure the distance should within 5mm.
87/89