ENGLISH
•
Remove the chuck by turning it
counterclockwise.
•
To refit the chuck, screw it onto the spindle
and secure it with the chuck retaining screw.
Residual risks
Additional residual risks may arise when using
the tool which may not be included in the
enclosed safety warnings. These risks can arise
from misuse, prolonged use etc.
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks can not be
avoided. These include:
•
Injuries caused by touching any
rotating/moving parts.
•
Injuries caused when changing any parts,
blades or accessories.
•
Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
ensure you take regular breaks.
•
Impairment of hearing.
•
Health hazards caused by breathing dust
developed when using your tool (example:-
working with wood, especially oak, beech
and MDF.)
Use
Warning! Let the tool work at its own pace. Do
not overload.
Warning! Before drilling into walls, floors or
ceilings, check for the location of wiring and
pipes.
10
Charging the battery (fig. A & F)
The battery needs to be charged before first use
and whenever it fails to produce sufficient power
on jobs that were easily done before. When
charging the battery for the first time, or after
prolonged storage, it will only accept an 80%
charge. After several charge and discharge
cycles, the battery will attain full capacity. The
battery may become warm while charging; this is
normal and does not indicate a problem.
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Recommended charging temperature: approx.
24 °C.
Using the charger
•
To charge the battery (7), remove it from the
tool and slide the charger receptacle (10)
onto the battery.
•
Plug in the charger (9).
The battery will become warm while charging.
After approx. 3 hours of charging, the battery will
be sufficiently charged for use in regular
applications. After approx. 8-10 hours of
charging, the battery will be fully charged.
•
Remove the charger receptacle from the
battery.
Charger with charging plug
•
To charge the battery, make sure that it is
fitted on the drill.
•
Insert the charger plug (8) into the connector.
•
Plug in the charger.
•
Switch on at the mains.