Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Adjusting the depth of cut (fig. B)
The depth of cut is indicated by the marking (9). The setting
range can be read from the graduation (6).
•
Turn the planing depth adjustment knob (5) to the
required depth of cut.
•
Turn the knob to the 'P' postion whenever the tool is not
in use.
Fitting and removing the parallel fence (fig. C)
The parallel fence is used to for optimum control on narrow
workpieces.
•
Thread the knob (11) into the hole on the side of the
planer and securely tighten.
•
Loosen the parallel fence adjustment knob (10).
•
Slide the parallel fence into the desired position.
•
Securely tighten the parallel fence adjustment knob.
Note : The parallel fence should be below the planer when
installed correctly.
•
To remove the parallel fence proceed in reverse order.
Connecting a vacuum cleaner to the tool (fig. D)
An adaptor is required to connect a vacuum cleaner or dust
extractor to the tool. The adaptor can be purchased from
your local Black & Decker retailer.
•
Slide the adaptor (12) over the shavings discharge outlet
(3).
•
Connect the vacuum cleaner hose (13) to the adaptor.
Fitting the shavings collection bag (fig. E)
The shavings collection bag is particularly useful when
working in confined spaces.
8
•
Slide the connecting plate (14) of the bag over either side
of the shavings discharge outlet (3).
•
To prevent chips from coming out opposite side of
shavings discharge outlet, move the shavings discharge
outlet selector (4) to the opposite side from the bag.
Emptying the shavings collection bag
The shavings collection bag should be emptied regularly
while using it to prevent blocking.
•
Unzip the bag and empty it before continuing.
Use
Warning! Let the tool work at its own pace. Do not overload.
•
Adjust the depth of cut.
•
If necessary, fit and adjust the parallel fence.
Switching on and off
Switching on
•
Keep the lock-off button (2) depressed and press the
on/off switch (1).
•
Release the lock-off button.
Switching off
•
Release the on/off switch.
Planing
•
Hold the tool with the nose piece of the shoe resting on
top of the workpiece surface.
•
Switch the tool on.
•
Move the tool steadily forward to perform the cutting
stroke.
Publicité
Table des Matières
