Hilti DAG700-P Mode D'emploi page 17

5.2.3 Fitting and removing the guard
(keyless) 4
NOTE
The guard is already set to the correct tension by way
of the adjusting screw. If the tension is found to be
en
too low when the guard is fitted, the adjusting nut can
be tightened slightly to increase the tension.
1. Disconnect the supply cord plug from the power
outlet.
2. Release the clamping lever.
3. Fit the guard onto the spindle collar so that
the keyed locating lug engages in the recess
provided.
4. Rotate the guard to the required position.
5. Secure the guard by closing the clamping lever.
6. To remove the guard from the power tool, follow
the instructions for fitting the guard but carry out
the steps in the reverse order.
5.2.4 Adjusting the guard (keyless) 5
1. Disconnect the supply cord plug from the power
outlet.
2. Release the clamping lever.
3. Rotate the guard to the desired position.
4. Close the clamping lever.
5.3 Fitting discs
DANGER
Check that the speed rating printed on the cutting
or grinding disc is equal to or higher than the rated
speed of the power tool.
DANGER
Check the condition of the grinding disc before
using it. Do not use discs that are broken, cracked
or damaged in any way.
DANGER
Do not use discs larger than 7" in diameter.
10
Printed: 07.07.2013 | Doc-Nr: PUB / 5069467 / 000 / 00
All manuals and user guides at all-guides.com
5.3.1 Fitting flat discs 6
CAUTION
When grinding with straight grinding discs and cut-
ting with cutting discs in metalworking applications,
use only the guard with cover plate. This is available
as an optional accessory.
WARNING
Use of a flat disc with an offset clamping flange
may lead to breakage of the disc.
1.
2.
3.
4.
5.
6.
7.
8.
5.3.2 Fitting offset discs 7
WARNING
Use of a flat disc with an offset clamping flange
may lead to breakage of the disc.
1.
2.
3.
4.
5.
6.
7.
Disconnect the supply cord plug from the power
outlet.
Clean the clamping flange for flat discs.
Place the clamping flange for flat discs on the
drive spindle.
Fit the flat disc.
Place the outer clamping flange for flat discs on
the drive spindle.
Screw on the clamping nut and tighten it.
CAUTIONDo not press the spindle lockbutton
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
Use the wrench to tighten the clamping nut
securely and then release the spindle lockbutton.
Disconnect the supply cord plug from the power
outlet.
Clean the clamping flange for offset discs.
Place the clamping flange for offset discs on the
drive spindle.
Fit the offset disc.
Screw on the clamping nut and tighten it.
CAUTIONDo not press the spindle lockbutton
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
Use the wrench to tighten the clamping nut
securely and then release the spindle lockbutton.