Charging; Changing The Brush Attachments - SilverCrest SSGRB 500 A1 Mode D'emploi

All manuals and user guides at all-guides.com
*%B1$6B6FKDOOUHLQLJXQJVEXHUVWHIP 6HLWH  )UHLWDJ  -XQL    
• The induction charging function enables
an enclosed design, meaning that the
device can also safely be used in the
shower.
Do not use
WARNING! Risk of injury!
~ Do not use the device on open wounds,
irritated skin, sunburn or blisters.
~ When using, avoid the area around the
eyes. The area around the eyes may
only be cleaned by hand, as the skin
around the eyes is thinner and more
sensitive.
~ Persons who have acne or other skin
conditions should consult a doctor be-
fore using the device.
~ Do not use the device if the brush at-
tachment shows damages.
~ Switch off the device before replacing
or changing a brush attachment.

6. Charging

NOTES:
• Charge the device for 15 hours before
using it for the first time, even when the
status indicator light|4 shows a steady
light.
• When the battery is fully charged, the
device can be used for approximately
40 minutes.
• The device has an overload protection
function, i.e. you can store it on the bat-
tery charger|5. When the battery is
charged, we recommend disconnecting
the power unit|8 and storing it in a suit-
able location.
1. Insert the small plug of the power unit
into the socket in the battery charger|5.
2. Lay the power unit|8 cable into the ca-
ble guide of the battery charger|5 and
place it onto a plane surface.
3. Switch off the facial cleansing brush|1
using the on/off button
quired.
4. Insert the power unit|8 into a readily ac-
cessible wall socket whose voltage
matches the voltage stated on the rating
plate.
5. Place the facial cleansing brush|1 into
the battery charger|5.
6. The status indicator light|4 will flash red
and the battery will begin to charge.
When the battery is fully charged, the
status indicator light|4 briefly lights up
red and then goes out.
7. Changing the brush
attachments
• Figure A: to attach the brush attach-
ments|6, carefully press the correspond-
ing brush attachment into the holder on
the head of the device. Make sure the
attachment clicks properly into position.
• Figure A: to remove a brush attach-
ment|6, hold it by the plastic disc and
pull it off the device.
|2 when re-
7
GB