Doro CONGRESS 200 Manuel D'utilisation page 4

English
Batteries
In order for the display, memory and other functions to operate, the telephone
requires three good quality AAA 1,5 V alkaline batteries to be installed. If
batteries are either not installed or running low, the
visible in the display, you will need to change the batteries as soon as possible.
The battery compartment is located on the underside of the telephone.
1. Ensure the telephone line cord is not connected to the telephone network
wall socket.
2. Remove the battery cover by pressing a small screwdriver (up to Ø 2,5mm) or
similar into the hole to the right of the cover.
3. Install the batteries ensuring correct battery polarity is observed.
4. Refit the battery cover.
Connection
Once the batteries have been installed:
1. Connect the curly cord to the handset and to the socket marked
underside of the telephone.
2. Connect the telephone line cord to the socket marked
the telephone and then to a telephone network wall socket.
3. A click will be heard when the modular plug is correctly in place.
4. Position the cables in the grooves underneath the telephone.
5. Lift the handset and listen for the dial tone. Your telephone is now operational.
Setting the Time
1. Lift the handset (ignore the dialling tone) and press
2. Press (to select 12/24 hour display please refer to page 11).
#
3. Enter time (Hours-Minutes-Seconds) using the telephone keypad (0-9).
4. Replace the handset. The time (clock) will be displayed after 5-10 seconds.
Hearing Aid Compatible
This telephone is hearing aid compatible. Select the T mode on your hearing aid
to enable this feature.
4
All manuals and user guides at all-guides.com
Installation
symbol will be
Mo bAtt
on the
q
on the underside of
T
and .
z
*
www.doro.com