EINHELL GE-TM 102 B&S Instructions D'origine page 25

completely into the attachment points.
•
Fig. 29: Lock the grass basket by exerting
slight pressure on the rear handle.
6. Operation
Note:
For detailed information on starting the engine, re-
fer to the enclosed manual from Briggs & Stratton.
Important.
The engine does not come with oil in it. Therefore,
be sure to add oil before starting the engine for
the fi rst time. You will also need to fi ll in petrol, as
this is also not supplied upon delivery.
Whenever you need to perform any adjustment
and/or repair work on your lawn mower, wait until
the blade has come to a complete stop. Always
switch off the engine before carrying out any ad-
justments, maintenance or repairs.
Warning: Never use more than one safety petrol
can. Do not smoke when refueling. Switch off the
engine before refueling and allow the engine to
cool down for a few minutes.
Safety switch
To prevent injuries from improper use, the lawn
mower is equipped with various safety devices.
To be able to start the engine, the following condi-
tions must be met:
•
Gear position → neutral
•
The mower unit must be switched off.
•
The operator must be sat on the seat.
•
The locking brake must be applied.
The engine cuts automatically whenever the ope-
rator leaves the seat.
Each time before use, check the tire pressure
and oil level.
Speed lever (Fig. 30)
Move the throttle lever (Item 14) in order to incre-
ase or decrease the engine speed. For optimum
mowing results we recommend that the throttle
lever should be set to the "Hare" position.
Tortoise = Slow
Hare = Fast
" " = Choke (enables a quick cold start)
Anl_GE_TM_102_BS_SPK7.indb 25 Anl_GE_TM_102_BS_SPK7.indb 25
GB
Lights (Fig. 30):
Vehicle lights ON/OFF (Item 15).
Note: The lights only work if the ignition lock is in
the "ON" position.
Mower unit switch (Fig. 31)
Use the ON/OFF switch for the mower unit (Item
16) to start the mower unit.
"I" = On
"O"= Off
Pay attention to the safety instructions.
Ignition lock (Fig. 31/Item 17)
Settings:
STOP= Turning off the engine
ON=Turning on the ignition
START=Starting the engine
Changing the fuse (Fig. 32)
If the 10A fuse (Item 32) is defective, replace it as
illustrated.
Important.
A defective fuse is always the result of a fault in
the electrical system. A check should be carried
out by an authorized service center.
Cutting height adjustment (Fig. 33)
Use the cutting height adjuster lever (Item 3) to
adjust the cutting height. Actuate the lever as
illustrated.
Safety switch, gear position → neutral
The driving pedals must be in neutral position.
When released, the driving pedals will automati-
cally adopt the neutral position. Take care not to
touch the driving pedals with your foot.
Note: The engine can be started only when the
driving pedals are in neutral position. If the pedals
and rods are dirty, neutral position might not be
adopted automatically. Keep the pedals and rods
free of dirt.
Test:
1. All the conditions for starting the engine must
be met (see point 6 „Operation").
2. Hold the ignition key in „Start" position. Simul-
taneously move the driving pedals from R to F
via neutral position.
3. The engine must turn briefl y upon passing
through neutral position (safety switch actua-
ted).
4. Adopt and hold neutral position until the engi-
ne starts.
- 25 -
26.11.15 08:36 26.11.15 08:36