Shoulder Bolsters; Height Adjustable Armrests - broda 30VT Mode D'emploi

3.6

Shoulder Bolsters

The Shoulder Bolsters provide upper torso support,
protection and containment and accommodate
asymmetries in the chair user. Their unique design
allows for proper elbow access to the arm rest. The
Shoulder Bolster is always used in conjunction with
the side wing.
To Attach the Shoulder Bolsters:
-Feed both Shoulder Bolster straps between the inner
strap of the wing and the frame of the chair.
-Secure the buckles and cinch the straps to secure the
bolster to the wing. The bolster can be slid up and
down the wing if desired.
Note: The Shoulder Bolster can be inverted on the
wing in order to provide support to narrower
residents.
3.7

Height Adjustable Armrests

The armrest height can easily be adjusted in order to
accommodate various residents. The armrest height
should be adjusted to provide correct arm support for the
resident as determined by the caregiver.
To Adjust Armrest Height:
-Using a 5/32" Allen wrench, loosen, but do not remove
the set screws.
-Raise or lower the armrest to the desired height and
tighten the bolts.
WARNING: Do not place fingers anywhere underneath
the armrest while adjusting as this could cause pinching.
-Secure the outside flap on the side panel. Change the
height of the other arm as desired.
13
2
1