How To Replace Brushroll Or Belt; Problem Solving - Eureka NEU180 Serie Mode D'emploi

How to replace brushroll or belt

C A U T I O N
1
!
Make sure vacuum is
turned off and power cord
is unplugged.
• Step on handle release and lay
vacuum cleaner face down.
• Use Phillips screwdriver to remove
6 screws from brushroll cover
(Fig. 1). Lift off cover. Refer to
Fig. 7 for location of screws.
• Rotate right end of brushroll and lift
out (Fig. 2).
• Lift out left end of brushroll.
• To replace belt, position new belt
3
around motor shaft (Fig. 3).
• Loop new belt around brushroll shaft
at left end of brushroll (Fig. 4).
• To reposition brushroll into base,
pull belt down and insert left end of
brushroll first. Align brushroll end
cap with slot so it fits into position
(Fig. 5). Press right end of brushroll
into position.
• To replace brushroll cover, align
slot on cover with tab (Fig. 6) and
snap cover into place. Replace 6
screws (Fig. 7).
5 6
12
Eureka Customer Service HELPLINE 1-800-282-2886
2
4
7
1
2
3
4
5
6

Problem solving

! Make sure vacuum is turned off and power cord is unplugged.
N O T I C E : Thermal cut-off
This vacuum cleaner has a special thermostat that protects the vacuum in case of motor
overheating.
If the vacuum suddenly shuts off, proceed as follows: 1) Push the power switch to off and
unplug the vacuum. 2) Check the vacuum for a possible source of overheating such as a full
dust cup, blocked hose or clogged filter. If these conditions are found, fix them and wait at
least 30 minutes before attempting to use the vacuum. 3) After the 30 minute period, plug
the vacuum back in and turn on the switch. If the vacuum still does not work, call the Eureka
Customer Service HELPLINE at 1-800-282-2886.
Problem
Motor will not start.
• Push plug securely into outlet, try another outlet or check
circuit breaker.
• Step on power switch to turn vacuum on.
• See detailed "thermal cut-off" instructions above.
Vacuum cleaner does • Empty dust cup, clean and/or change filter.
not clean floors.
• Clean or replace filter regularly to maintain suction.
• Check vacuum height adjustment knob position.
• Clean brushroll if needed. Page 11.
No suction at the end • See other solutions above.
of hose or wand.
• Remove clogs from the hose or wand that restrict
the airflow. Page 10.
Burning smell; • Check brushroll for debris.
brushroll will not turn.
• Replace broken or out of shape belt. Page 12.
Vacuum is hard to push.
• Adjust vacuum height knob to a higher position.
• Check brushroll for debris and clean if needed. Page 11.
Turbo brush will not • Check turbo brush for debris. Page 11.
turn (select models:
NEU182-NEU188
except NEU182A).
Solution
13
www.eureka.com