Table des Matières
Publicité
1.
2.
3.
4.*
6.
10
5.
Hose Suction
Control Button
ENGLISH
INSTRUCTIONS FOR USE
•
Before operating the vacuum cleaner, make certain that the dust bag
and filters are in the proper position.
1 Pull all of the power supply cord out from back of cleaner and plug
into electrical outlet.
Note: When pulling on power supply cord watch for a yellow line on
the cord. Then continue slowly pulling on cord till you see the red
line, stop. The red line indicates the end of usable cord.
2
Push the ON/OFF ( I ) button to switch the cleaner on.
3
To rewind the power cord, press the rewind button with foot and
guide the cord with hand to ensure that it does not whip causing
damage.
5
The suction control button on the hose handle is used to reduce suc-
tion for delicate work such as cleaning drapes or picture frames.
HOW TO USE
Floors should be cleaned regularly over heavily traveled areas, and once
a week over the entire area. Vacuum slowly, making several passes (for-
ward and backward), covering small areas at a time. The time required to
clean will depend on several factors - including type of floor and amount
of dirt.
CLEANING TOOLS
4*
Combination Floor Nozzle: For carpets or hard surface floors.
5
Hose Suction Control Button: For use to increase or decrease
suction when using cleaning tools.
Combination Crevice Nozzle/Brush Tool: (stored in rear of
6
cleaner): For crevices, corners, baseboards, between cushions.
Brush rotates to allow use as brush or crevice depending on task.
*on some models.
* Depending on model
Publicité
Table des Matières
