Remington Flex360 Mode D'emploi page 7

ENGLISH
, CHANGING SHAVE / GROOMING HEADS
•
The shaver should be switched off when changing heads.
•
Grasp the shave head at the red collar and pull up to unsnap the head from
the handle.
•
Attach the interchangeable heads to the handle by aligning the hexagon
shapes of the head to the handle, then pressing together to snap in place.
•
To remove the interchangeable heads gently pull the head upwards until it
comes off the main body of the product.
, NOTE: The Deep Clean and Pre-shave head must be clicked into place on
top of the brush base. The brush base can then be connected onto the
product by aligning the hexagon shapes of the brush base to the handle as
noted above.
, GROOMING
•
Use the grooming styler head without the adjustable comb for trimming
hair close to the skin. This will trim hair to 1mm, holding the blades
perpendicular to the skin will trim hair to 0.4mm.
•
Attach the comb onto the groomer head by hooking the front of the comb
over the trimmer blades, then snapping the comb down onto the groomer.
•
Adjust the comb setting by rotating the thumb wheel at the top of the
comb clockwise to increase the cut length and anticlockwise to reduce the
cut length. Read the setting printed on the comb to select your desired
length.
•
Place the grooming styler head against the skin and slide the clipper blade
against the growth direction of the hair. The comb will lift the hair and trim
it to a consistent length.
Comb Position
1
2
3
4
5
Cutting length
2mm
3mm
4mm
5mm
6mm
7