Remington Flex360 Mode D'emploi page 5

ENGLISH
C GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to
allow time for your beard and skin to become accustomed to the new shaving
system.
, CHARGING YOUR SHAVER
•
Ensure the appliance is switched off. Connect the adaptor to the product
and then to the mains.
•
Allow four hours for a full charge. The charging indicator light will indicate
when the shaver is fully charged.
•
When charge is low, the top LED will illuminate a solid red light. When
charging the bottom LED will illuminate a solid green light. When fully
charged, both LED's will be off.
•
To preserve the life of your batteries, let them run out every 6 months then
recharge for 4 hours.
•
The shaver automatically adjusts to a mains voltage between 100V and
240V.
F INSTRUCTIONS FOR USE
, SHAVING
, Note: This shaver is for cordless use only.
•
Make sure your shaver is properly charged.
•
Switch the shaver on by pressing the On/Off button.
•
Stretch the skin with your free hand so that the hairs stand upright.
•
Only apply light pressure on the shaving head while shaving (pressing too
hard can damage the heads and make them vulnerable to breakage).
•
Use short, circular strokes.
E TIPS FOR BEST RESULTS
•
Use moderate to slow stroking movements. The use of short circular
motions in stubborn areas may obtain a closer shave, especially along the
neck and chin line.
, DO NOT press hard against the skin in order to avoid damage to the rotary
heads.
5