Black & Decker Powerful Solutions KR504RE Traduction Des Instructions D'origine page 7

• If the supply cord is damaged, it must be re-
placed by the manufacturer or an authorised
Black & Decker Service Centre in order to avoid
a hazard.
Features
1. Variable speed switch
2. Lock-on button
3. Forward/reverse button
4. Drilling mode selector
5. Chuck
6. Depth stop (not all models)
7. Side handle (not all models)
fi g. B
8. Manual spindle lock button (single sleeve key-
less chuck only)
Assembly
Warning! Before assembly, make sure that the tool
is switched off and unplugged.
Fitting the side handle and depth stop (fi g. A)
• Turn the grip counter clockwise until you can
slide the side handle (7) onto the front of the
tool as shown.
• Rotate the side handle into the desired posi-
tion.
• Insert the depth stop (6) into the mounting hole
as shown.
• Set the drilling depth as described below.
• Tighten the side handle by turning the grip
clockwise.
Fitting a drill bit
Single sleeve keyless chuck (fi g. B)
• Open the chuck by pressing the manual spindle
lock button (8) and turning the sleeve (9) counter
clockwise.
• Insert the bit shaft (12) into the chuck.
• Firmly tighten the chuck by pressing the manual
spindle lock button (8) and turning the sleeve
clockwise until it is tight.
Two sleeve keyless chuck (fi g. C)
• Open the chuck by turning the front part (10)
with one hand while holding the rear part (11)
with the other.
• Insert the bit shaft (12) into the chuck and fi rmly
tighten the chuck.
Keyed chuck (fi g. D)
• Open the chuck by turning the sleeve (13) coun-
ter clockwise.
• Insert the bit shaft (12) into the chuck.
• Insert the chuck key (14) into each hole (15) in
the side of the chuck and turn clockwise until
tight.
Removing and refi tting the chuck (fi g. E)
• Open the chuck as far as possible.
• Remove the chuck retaining screw, located
in the chuck, by turning it clockwise using
a screwdriver.
• Tighten an Allen key into the chuck and strike it
with a hammer as shown.
• Remove the Allen key.
• Remove the chuck by turning it counter clock-
wise.
• To refi t the chuck, screw it onto the spindle and
secure it with the chuck retaining screw.
Use
Warning! Let the tool work at its own pace. Do not
overload.
Warning! Before drilling into walls, fl oors or ceilings,
check for the location of wiring and pipes.
Selecting the direction of rotation (fi g. F)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or re-
moving a jammed drill bit, use reverse (counter
clockwise) rotation.
• To select forward rotation, push the forward/re-
verse button (3) to the left position.
• To select reverse rotation, push the forward/re-
verse button to the right.
Warning! Never change the direction of rotation
while the motor is running.
Selecting the drilling mode
• For drilling in masonry, set the drilling mode
selector (4) to the
• For drilling in other materials and for screwdriv-
ing, set the drilling mode selector to the posi-
tion.
Setting the drilling depth (fi g. G)
• Slacken the side handle (7) by turning the grip
counter clockwise.
• Set the depth stop (6) to the desired position. The
maximum drilling depth is equal to the distance
between the tip of the drill bit and the front end
of the depth stop.
• Tighten the side handle by turning the grip
clockwise.
Switching on and off
• To switch the tool on, press the variable speed
switch (1). The tool speed depends on how far
you press the switch. As a general rule, use
ENGLISH
position.
7