Kubota GZD15-3 LD Instructions De Montage page 16

12
BInstalling the Upper ROPS Pipe
Use 2 set pin assies, locking nuts and bolts to install PIPE,
ROPS UPPER (1) to PIPE, ROPS UNDER.
Tightening torque: 50.0 to 60.0 N-m
5.1 to 6.1 kgf-m
(1) PIPE, ROPS UPPER
(2) Set pin
(3) BOLT (M16)
(4) NUT (M16)
BAdjustment of Foldable ROPS
A Adjust free fall of the ROPS upper frame regularly.
A If you feel less friction when folding the ROPS, tighten
the nut (1) until you feel the right friction in the
movement and then replace the cotter pin.
(1) Nut
All manuals and user guides at all-guides.com
BInstalling the Front Guard
1. Remove 2 existing bolts. (These bolts will not be
(1) Existing bolt (M10)
2. Use 2 bolts, 2 nuts and 2 washers to install GUARD
(1) GUARD (FRONT)
(2) Bolt (M10 x 100)
(3) Nut (M10)
(4) WASHER, SPRING
used.)
(FRONT) to the weight bracket as shown in the figure
below.