Kubota GZD15-3 LD Instructions De Montage page 15

<Low Dump>
Assemble the grass catcher container by referring to
GC400HZ grass catcher instruction manual.
INSTALLATION OF TIRE, MOWER, LABEL,
LOW DUMP GRASS CATCHER AND SO ON
BPutting the Tires
1. Lifting the machine
For the front, apply nylon slings around the front axle.
For the rear, apply nylon slings around the right and
left frames.
2. Putting the front tires
Fix the tire (1) to the front axle with the bolt (2) and nut (3).
Tightening torque: 20 to 25 N-m (2.0 to 2.5 kgf-m)
A When removing the hubcap from the front wheel, be
careful not to drop and lose the collar.
A Direct the wheel bracket backwards and place the tire
(1) with the air valve outwards, as shown below.
A Turn the front tire by hand to make sure it turns
smoothly.
A Insert the bolt (2) from outside and apply the nut (3)
inside.
A Tighten the nut gradually until wheel bearing play is
eliminated and wheel turns freely by hand.
All manuals and user guides at all-guides.com
(1) Tire
(2) Bolt (M12 x 210)
(3) Nut (M12)
3. Putting the rear tires
Fix the tire (1) to the rear axle with the bolts (2) (4 pcs. for
each side).
Tightening torque: 77.5 to 90.2 N-m (7.9 to 9.2 kgf-m)
(1) Tire
(2) Bolt
A For the tire pressure, refer to the Operator's Manual.
A Place the tire (1) with the air valve outwards.
11
(A) Wheel bracket
(B) Air valve