Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY OF THE GRASS CATCHER
CONTAINER
<High Dump>
BPreparations for Assembling the Under
ROPS Pipe
1. Make a team of two to do this job.
2. Remove the bolt (1) and nut (2) from the lift rod (for
both sides).
The bolt (1) will be used again to reassemble this
component. Be careful not to lose them. (The nut (2)
will not be reused.)
(1) Bolt
(2) Nut
(3) Lift rod
(4) Under ROPS pipe
BInstalling the Under ROPS Pipe
1. Remove the snap pin (1) that keeps the cylinder (A) in
place.
(1) Snap pin
(A) Cylinder
All manuals and user guides at all-guides.com
2. Remove the 4 bolts (2) first and then the fixing plate
(1) Fixing plate
(2) Bolt
3. Using the bolts (3), temporarily connect the pipes
(1) PIPE, ROPS UNDER
(2) Cylinder
(3) Bolt (M14 x 30)
(4) Headed pin
(5) Snap pin
(1). (The same for both sides)
4 bolts (2) will not be reused.
(A) PIPE, ROPS UNDER
(B) Frame
(ROPS, UNDER) (1) to the frame (3). (4 bolts each for
each side)
Fix the cylinder (2) to the frame (A) with the headed pin
(4) and snap pin (5).
(A) Frame
7
Publicité
