Kubota GZD15-3 LD Instructions De Montage page 12

8
BInstalling the Lift Arms (Upper and Lower)
(1) Bag base
(2) PIPE, ROPS UNDER
(3) Upper lift arm
A There are two upper lift arms. The lift arm that has a
stay is for the right side. Be careful not to confuse the
right and left ones and to keep the stay outward.
C Under ROPS pipe side
Using bolts, washers, collars and nuts, install the upper lift
arm and the lower lift arm to PIPE, ROPS UNDER.
Tightening torque: 40 to 50 N-m (4.1 to 5.1 kgf-m)
A Set the washer on the nut side. Insert the bolt from the
outside. For the lower lift arm, set the cylinder
mounting bracket downward
A Apply grease between the lift arm and PIPE, ROPS
UNDER.
(1) Bolt (M14 x 70)
(2) Washer
(3) Collar
(4) Nut (M14)
All manuals and user guides at all-guides.com
(4) Lower lift arm
(5) Cylinder mounting bracket
(6) Stay
(5) Upper lift arm
(6) Lower lift arm
(7) PIPE, ROPS UNDER
C Bag base side
(Right side lower lift arm)
1. Remove the headed pins and take off the arm cam
from the bag base.
2. At the right side, using the arm cam, collars and
washers, install the lower lift arm.
3. Fix the arm cam with the headed pin and the snap pin.
A Set the washers on the inside of the bag base only.
(1) Headed pin
(2) Snap pin
(3) Washer
(4) Bag base
(1) Arm cam
(2) Collar
(3) Lower lift arm
(4) Bag base