S&P HTL-130 4F Notice D'installation Et D'utilisation page 18

MODEL
HTL-130 4F
HTL-130 1G
Note: Light bulbs are not supplied.
ASSEMBLY OF THE LAMp KITS
IMPORTANT: Remember to disconnect the fan from the mains supply (mains fuse or contact breaker)
before working on the fan.
1.- Connect the lamp kit cables using the lower fan electrical connectors. The cables are marked
and should coincide with the correct connector.
2.- Fit the cables inside the assembly, align the holes of the two halves of the assembly and tighten
the screws using the safety washers supplied. The HTL-130 1G has a decorative fitting to fix
the glass globe. (Fig. 11)
NOTE: Remember to connect the red lamp cable and the mains supply connector (brown). (Fig.12)
MAINTENANCE
1.- Periodic cleaning is the only maintenance required.
2.- Clean the fan using a soft brush or soft cloth to avoid damaging the finish.
3.- When carrying out maintenance work, do not use the fan blades as a support as they could
become unbalanced and so increase the vibration of the fan.
4.- Do not use abrasive cleaning agents as these could damage the finish of the fan.
5.- Do not use water when cleaning the fan as this could cause damage to the motor and deform
the fan blades.
6.- Furniture polish can be used to clean wooden fan blades.
IMPORTANT: Before carrying out any maintenance work on the fan, ensure that it is disconnected
from the mains electrical supply.
IMPORTANT: Before working on the fan, ensure that it is disconnected from the mains supply.
All manuals and user guides at all-guides.com
LAMP KIT
MOVEABLE
17
MAXIMUM POWER
4x60W
2x60W