S&P HTL-130 4F Notice D'installation Et D'utilisation page 17

screws on both sides of the cotter pin (Fig. 8)
3. First fix the support plate(A) to the ceiling using the screws (P), and the wall plugs (S) provided
then attach the fan to the hook on the back plate using the hole in the canopy (B) In this way the
electrical connections can be made between the mains supply cables and the fan connectors
(Fig. 8). (Fig. 12)
IMPORTANT: The red cable in the fan is part of a separate circuit to be used with the lamp kit.
(depending on model). If you have a model with lamp kit, the red cable should be connected to
the L connection (brown). For non lamp versions the red cable should be ignored. (Fig.12)
4. Complete the assembly of the fan/wall plate by fixing the canopy using the four screws (Q)
and the safety washers (R) supplied. Ensure that the screws are well tightened (Fig. 1)
2- Fitting the fan blades
IMPORTANT: If you are installing more than one ceiling fan make sure that you do not mix fan
blade sets, even though they are from the same ceiling fan model.
1.- a) Place the fan blade (L) on the floor with the chosen colour facing down. Use the felt
washers (M) to avoid damage to the blade and join the blade to the blade support (K) using the
screws supplied (N), but do not tighten fully (Fig. 9)
Once the screws and washers are in position for all blades, start to tighten the screws beginning
with the screw in the centre of each blade. Ensure that the blade is straight.
b) (HTL 130-1 G Model) Place the fan blade (L) on the floor with the chosen colour facing down.
Align the holes in the blade support (K), the blade (L) and the blade fixing bracket (T) . When
the holes in all three components are aligned complete the assembly using the screws supplied
(N), but do not fully tighten the screws (Fig.10)
Once the screws and washers are in position for all blades, start to tighten the screws beginning
with the screw in the centre of each blade. Ensure that the blade is straight.
2.- Join the complete assembly to the motor using the screws (J) & the safety washers (I).
Repeat the process with the rest of the blade assemblies. (Fig.9) or (Fig.10)
3.- The lamp kit can be installed at this time following the instructions provided (According to
model ). (See following page)
OpERATION INSTRUCTIONS
1.- The chain pull switch on the motor has four positions.
1) Pull once....
2) Pull again...
3) Pull again...
4) Pull again...
IMPORTANT: This product must not be used in conjunction with solid state control devices.
2.- The small sliding switch (on the side of the housing) controls the airflow direction. All fans are factory
supplied with the switch in the downward airflow position. If you require the airflow in the opposite
direction, switch the fan off, wait for it to stop and move the sliding switch to the opposite position.
The fan will now rotate in the opposite direction and the airflow will be reversed.
3.- Lamp kit.
1) Pull.......... ON
2) Pull again.. OFF
All manuals and user guides at all-guides.com
ON (High speed)
ON (Medium speed)
ON (Low speed)
OFF
16