Dustbane Gladiator 464 Manuel De Pièces Et D'opérations page 8

Masquer les pouces Voir aussi pour Gladiator 464:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Main Brush Replacement:
Cleaning and Servicing the Filters
The filters are very important components of the machine and essential for correct operation. Proper filter
maintenance will allow you to obtain the best performance from your machine.
Pre-Filter
Clean Daily
1) Remove the debris hopper to access the pre-filter.
2) Release the two metal retaining clip arms that secure the pre-filter in place. Hinge the retaining clip arms outward and remove
the pre-filter.
3) Shake the pre-filter into a debris receptacle.
4) Replace the pre-filter and secure with retainer clips.
Main Filter
The Main filter can be cleaned in any of the following three ways:
1) By means of the automatic filter shaker: During operation, the machine will automatically activate the filter shaker every 3 minutes.
2) By means of manually activating the filter shaker: Just a simple command is needed to keep the filter in perfect working order:
press the button marked 'E' and hold it down for a few seconds. Repeat this operation 4 or 5 times. Remember that the cleaner
the filter, the better the results of your cleaning session. It is recommended to carry this good idea to use the manual filter shaker
more frequently.
3) By manually cleaning the filter: Manually clean the filter when the filter shaker is not enough to keep the filter clean and/or every
20 hours of work. Before carrying out any kind of procedure on the machine, make sure it is turned off and that all functions are
deactivated.
8
Tilt the machine backwards until the handle is touching the
ground and the main brush is easily reached.
Manually turn the brush until a black button is seen on the
right hand side of the brush core.
Press the button and push to dis-engage the brush.
Insert the new brush following the guide.
Filters in Rear Hopper
1) Remove the rear hopper
2) Take the filter out
3) Blow compressed air into the side of the filter (at a pressure of 87 psi at
the most). Safety glasses required.
4)Reinstall the filters and the rear hopper.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

19677

Table des Matières