Programming Instructions - Dustbane Gladiator 464 Manuel De Pièces Et D'opérations

Control Panel Display Codes
CODE
C22
C14
FS0
SP1
Yellow
led lit
Red led flashes
P1.X
P2.X
SF.X
X = A VAlUE fROM "0" TO "9"
Programming
Your machine is factory programmed for optimum performance. It does not require further programming. However, if you encounter
one of the following codes; P1.x, P2.x or SF.x (x= a value from 0 to 9), use the following programming instructions to reset your
display. Operating the machine in a setting other than the factory setting may cause machine failure. Machine damage due to
improper programming will void your warranty.

Programming Instructions

If your display reads P1.0 , P2.1 or SF.3 simply turn the main power off and back on again to reset display (these are the factory
programmed settings). If your display reads a value greater than stated above (ex. P1. " 5" , P2. " 7" , SF. " 9") continue to follow the
instructions as described below.
To reprogram the machine to the factory settings, turn the main power ON and press and hold the display switch button (battery/
time symbols) down for at least 3 seconds. P1.x will appear on the display. The P1 value should read "0" (ex. P1.0). If the value is
greater than "0", press the vacuum fan button until the display reads P1.0. Press the display switch button again to advance to the
next code. The P2.x value should read "1" (ex. P2.1). Press the vacuum fan button to properly set. Press the display switch one more
time to advance to the last code. This code should read SF.3. If the value is not "3", press the filter shaker button until the display reads
SF.3. To exist the programming mode, turn machine off.
10
CAUSE
Short circuit brush protection: stops all functions
Dissipater at high temperature. Activates if
temperature is over 194° F.
Worn brushes
Brushes KO
Battery in reserve
Battery discharged
Sweeping mode 1 button programming activated
Sweeping mode 2 button programming activated
Filter shaker program setting activated
SAFETY CODES
Reset by turning off the machine and starting again..
The machine resets when temperature lowers under
176° F.
Replace brush
Error can only be reset by turning off the machine
This alarm condition arises if the brushes are put in
SHUTDOWN condition three times in a minute.
Machine continues to work. Only a warning that the
battery is near discharge
Machine stops all functions Turn off machine and
charge the battery
See programming
See programming
See programming,.
SOLUTION