Machine Maintenance - Dustbane Gladiator 464 Manuel De Pièces Et D'opérations

Waste Hopper Emptying And Cleaning
Before proceeding in removing the hopper assure that the machine is turned off.
Waste disposal must be done by following the laws in force. To clean the waste hopper proceed as follows:
• Release the hopper clamp by lifting and then pushing on the back of the clamp.
• Pull out the hopper by its handle
• Empty the hopper
To put back the hopper proceed as follows:
• Slide the hopper back into place
• Lower and press the hopper clamp to lock into place.
NOTE: It is recommended to clean the pre-filter daily. See cleaning and servicing the filter-page 7.

Machine Maintenance

All service performed should be completed by persons who understand the machine or an AUTHORIZED SERVICE CENTER. It is
recommended that only authorized repair parts be used for service. FOR SAFETY: When servicing the machine disconnect the
battery connection and battery charger plug before working on the machine.
Side Brush Replacement
• Raise the front part of the machine.
• Press in the 2 tabs (indicated by the arrows) and pull off the brushes,
• Slide the new brush until it locks into place.
7