Icar RPC 5LGA Guide Rapide page 7

ICAR PQS
Main page
With the  keys it is possible to move through the available pages. With the  key, the MAIN MENU page is
accessed.
With the  keys, to the display of additional steps that may be present in addition to those of the page 1/4 is
accessed.
Main menu
Select the desired menu with the  keys and confirm with the  key. The selected menu is highlighted in
reverse and at the centre a text description appears.
Select this icon to set the MANUAL MODE (MAN).
Select this icon to set the AUTOMATIC MODE (AUT).
Description and meaning of the alarms
CODE ALARM
A01 Under-compensation
A03 Current too low
A04 Current too high
A05
Voltage too low
Descriptive text field. It can be changed from the SETUP menu  M01 UTILITY
 P01.09 SITE ID
System real time cosφ. IND= inductive, CAP= capacitive
State of steps controlled by the controller. Black symbol: step inserted. Gray
symbol: step not inserted. Absent symbol: exit not used. Gray number: step
temporarily not available (for example: step just switched off)
Weekly true power factor, calculated on the last 7 days
Equipment internal temperature and fan status (
AUT= automatic mode; MAN= manual mode
Reactive power missing (with "+" indication) or reactive power in surplus (with "-"
indication) compared to the set target cosφ
Phase to phase voltage real time THD%
System current real time THD%, in the CT installation point
MEANING
All the available steps are connected but the cosφ is still
more inductive than the setpoint.
The current flowing in the current inputs is lower than
minimum measuring range.
This condition occurs normally if the plant has no load.
The current flowing in the current inputs is lower than
minimum measuring range.
The measured voltage is lower than the threshold set with
P17.14.
7 / 12
ALL65 rev7 jan18
= stop; = start)