RFC L-PAD 12C Manuel Utilisateur page 6

All manuals and user guides at all-guides.com
FUNCTIONS
MAIN MIX output: XLR balanced male connectors. Plug in your active speakers or main
sound reinforcement system amplifier (for passive speakers) of here. The output level is
+4 dBu. This output is repeated on the TRS jack.
CONTROL ROOM output: Plug your studio monitor or local speakers into these TRS
jacks.
GROUP OUT output: TRS jacks. Plug in the lines to be routed to locations or devices
other than MAIN here.
AUX1 & AUX2 SENDS outputs: Plug a wedge stage monitor or external FX device into
these TRS jacks. The processed signal from the FX device is returned to the RCF mixing
consoles mixer via the Stereo Return jacks.
PHONES: TRS stereo jack, Tip = Left, Ring = Right, Sleeve = Common Earth. Plug in your
headphones here to listen to MAIN MIX or PFL when pressed.
OUTPUT LEVEL: These LEDs show the MAIN MIX OUTPUT level.
Keep under CLIP level to prevent generating distorted sounds or dangerous sound levels.
ST RETURN control: This defines the STEREO RETURN input signal level routed to MAIN
MIX output.
TO AUX control: This defines the signal STEREO RETURN input level routed to AUX1
output.
SEND AUX1 control: This is the AUX1 send master level control.
SEND AUX2 control: This is the AUX2 send master level control.
CONTROL ROOM/PHONES control: This defines the signal level routed to CONTROL
ROOM output and PHONES output.
MAIN MIX-GROUP1-2 switch: In upper position allows you to listen the MAIN MIX
through the CONTROL ROOM speakers. When pressed, it allows to listen to GROUP1‑2
via the CONTROL ROOM speakers.
2TK IN/MP3 control: This defines the signal level from the 2TK IN input or from optional
cards (such as the RCF mixing consoles player, recorder or Bluetooth cards) routed to
MAIN MIX output.
TO MAIN MIX/TO CONTROL ROOM switch: Defines where to route the signal coming
from 2TK IN or optional cards: to MAIN MIX when in upper position, to CONTROL
ROOM when pressed (lower position).
FADER GROUP 1-2: GROUP 1‑2 signal level control. The GROUP 1‑2 signal is routed to
the MAIN MIX when the L‑R button is pressed.
FADER MAIN MIX: MAIN MIX output level control.
6