RFC L-PAD 12C Manuel Utilisateur page 5

FUNCTIONS
STEREO LINE INPUT (Ch. 5/6 - Ch. 11/12). Plug in your keyboard, line level or stereo devices here. Gain scale +15 dB/‑35 dB (Ch. 5/6 ‑ Ch. 7/8). The
corresponding channel works as a mono channel when MIC input 5‑6 or 7‑8 is used.
EQ: A three‑band EQ is available for mono channels:
HI = ±15 dB@12 kHz
MID = ±15 dB@2.5 kHz
LOW = ±15 dB@80 Hz
Dual‑band EQ for stereo channels:
HI = ±15 dB@12 kHz
LOW = ±15 dB@80 Hz
AUX1 Auxiliary send, level ‑∞ to +15 dB. The signal
is routed to the AUX SEND output jack. The POST/PRE
function determines whether to extract the signal after
the fader position or independently from it.
PRE/POST button: When released, the signal is
extracted in pre‑fader position (independently from the
fader level); when pressed, the signal is extracted from post‑fader position (the send level depends on the fader level).
AUX2: it is an auxiliary send, level ‑∞ to +15 dB. The signal is routed to the AUX2 SEND output jack. The signal is extracted in post‑fader position.
PAN or PAN/BAL: This control defines the signal position
into the stereo image in case of a MONO channel or
the balance between left and right in case of a STEREO
channel.
MUTE button: Pressing this button (red led lights)
mutes the channel.
PFL button: Pressing this button allows you to listen the
signal through the PHONES output even if the fader is
in ‑∞ position or muted. This function is useful to check
the channel input level (see the OUTPUT LEVEL meter).
GROUP 1-2 button: Press this button to route the
channel signal to the group 1‑2 audio output. In this
case, the PAN/BAL position control defines the quantity
of signal routed to GROUP 1 or GROUP 2.
L-R button: Press this button to route the channel signal
to the MAIN MIX output.
FADERS Ch. 1 - Ch. 4: MONO Channels level control
FADERS Ch. 5/6 - Ch. 7/8: MONO/STEREO channels level control
FADERS Ch. 9/10 - Ch. 11/12: STEREO channels level control
All manuals and user guides at all-guides.com
RCA LINE INPUT (Ch. 9/10 - Ch. 11/12). Plug in your low‑level or consumer devices, like
CD players, computers or mobile phones here (adapter needed).
STEREO RETURN Connect signals from external devices, such as FX
modules, to these unbalanced TRS jacks.
2TK IN – 2TK OUT These unbalanced RCA
connectors are suitable for connecting audio
player and recorder devices.
5