Operating The Transmitter; Switching The Transmitter On/Off; Aligning The Transmitter; Night Vision - AUDIOLINE Watch & Care V90 Mode D'emploi

Operating the Transmitter

Operating the Transmitter
Check the transmitter and receiver are working properly each time before the equipment is put into
operation.

Switching the transmitter on/off

Press and hold the On/Off button for approx. 3 seconds.
The POWER on/off indicator will flash until the connection to the receiver is established. Then the
LED will light constantly.
To switch the unit off, press and hold the On/Off button for approx. 3 seconds.

Aligning the transmitter

a
Attention: Position the transmitter with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance. Point the upper section of the transmitter towards the
baby or object you want to monitor. Check that the baby or object is suitably displayed on the
receiver.

Night vision

The transmitter is equipped with infrared diodes. This enables the transmission of pictures from areas
which are not illuminated. The night vision function is activated automatically when the light conditi-
ons make it necessary.
When the night−time vision function is activated, the screen display on the receiver turns to
black and white.

Setting the loudspeaker volume

You can adjust the volume of the voice playback in your baby's room on the transmitter (camera)
Press ▲/VOL to increase the volume or ▼/VOL to decrease the volume.
GB
5