Starting Up; Checking The Package Contents; Putting The Receiver Into Service; Installing The Battery - AUDIOLINE Watch & Care V90 Mode D'emploi

Starting Up

Starting Up
a
Important: please make sure you've read the safety information on page 8 before you set up
your system.

Checking the package contents

The package contains:
1 Monitor unit (receiver)
1 Rechargeable battery pack for the receiver
1 Power adapter plug for the receiver

Putting the receiver into service

You can power up the parent unit by connecting it to AC power or to the rechargeable battery provi-
ded. Even if the parent unit is connected to AC power, it is recommended you also install the battery.
This guarantees continual operation in case of a power outage.

Installing the battery

Install the battery as shown below. Only use the rechargeable battery pack supplied or similar ones.
1 Push the detent of the battery compartment cover and lift the cover to open.
2 Plug the battery connector securely into the socket.
The connector is polarized.
Arrange the battery wire to avoid it obstructing the battery cover when closing.
3 Align the battery compartment cover against the battery compartment.
4 Push the battery compartment cover down and click into place.
The battery pack charges directly in the device when the AC adapter is connected.
While charging, the battery icon lights up. When the battery has very little charge, the battery icon
flashes. The battery must be charged.
The battery icon goes off when the battery is fully charged.
As operation time is limited by battery power, wherever possible operate the device using the power
supply.
Note: During long periods of disuse, remove the battery from the device in order to prevent any
leakage from the battery.
1 Camera unit (transmitter)
1 Power adapter plug for the transmitter
1 Operating manual
GB
3