Table des Matières
Publicité
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
valves
spout
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
Inspect this product for damage before
installation. Claims for transport damage
made after installation will not be honored.
• 76034xx1 only: This faucet does not include a
drain or a pull rod.
• 76033xx1 only: The drain is suitable for most, but
not all, lavatory sinks sold in the United States and
Canada. The drain is intended for use in a sink with
an overflow. If your sink does not have an overflow,
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (5.4 L/min)
1³⁄₁₆"(30 mm)
1³⁄₁₆"-1⁵⁄₁₆" (30 mm - 34 mm)
1³⁄₁₆"(30 mm)
or if this drain is too small for the hole in your sink,
please refer to the instructions included
with the sink. Some sinks include special drain
installation instructions and/or parts. Others require
the use of a specialty drain. Hansgrohe is not
respnsible for the cost of a specialty drain.
The hot and cold supply hoses included
with this faucet are for use with ⅜ stops. If
your stops are a different size, purchase adapters
at your local plumbing supply store or home center.
Adapters are not available from Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
Table des Matières
