Miele S 770 Mode D'emploi page 32

en
Fitting the floorhead (dia. 8 + 9)
The floorhead can be used for all
normal cleaning of carpets and rugs.
It can also be used with the brush
protruding to vacuum hard flooring.
It is important to observe the flooring
manufacturer's cleaning and care
instructions.
Depending on model, the floorhead will
have the following symbols:
– ö and ä
– % and )
Vacuum carpets and rugs with the
brush retracted:
^ Press the ö or % foot control.
Clean hard flooring which is not
susceptible to scratching with the brush
protruding:
^ Press the ä or ) foot control.
Clean flooring which has deep
crevices or grooves with the brush
protruding.
Using the accessories supplied
(dia. 10)
The following accessories are supplied:
a Crevice nozzle
b Dusting brush
c Upholstery nozzle
32
All manuals and user guides at all-guides.com
Opening the accessories compartment
(dia. 11)
^ Press the release button to open the
^ Take out the accessory you require.
^ Press down firmly on the lid to close
Floorhead (dia. 12)
For general use and also for vacuuming
stairs.
Use
Unwinding the cable (dia. 13)
^ Pull the mains cable out to the requi-
^ Insert the plug in the socket correctly.
Rewinding the cable (dia. 14)
^ Switch the vacuum cleaner off at the
^ Press the rewind foot control briefly.
Switching on and off (dia. 15)
^ Press the On/Off foot control s.
accessories compartment lid.
it.
Warning: For safety reasons when
vacuuming stairs it is best to start at
the bottom of the stairs and move
upwards.
red length (max. approx. 5.5 m).
Warning: If vacuuming for longer
than 30 minutes, the mains cable
must be pulled out to its fullest
extent. Otherwise there is a danger
of overheating and damage.
wall socket and unplug it.
The cable will rewind automatically.