Power Failure - AUDIOLINE Watch & Care V161 Mode D'emploi

Appendix

Power failure

In the event of a power failure, the devices only operate through battery power. Disconnect the power
adapter plugs from the devices in this case.
Medical equipment
a
Attention: Never use the devices in the vicinity of medical equipment.
Effects on such equipment cannot be fully ruled out.
Disposal
In order to dispose of your device, take it to a collection point provided by your local
public waste authorities (e.g. recycling centre). According to laws on the disposal of
electronic and electrical devices, owners are obliged to dispose of old electronic and
electrical devices in a separate waste container. The adjacent symbol indicates that
the device must not be disposed of in normal domestic waste!
Batteries represent a hazard to health and the environment! Never open, damage or
swallow batteries or allow them to pollute the environment. They may contain toxic,
ecologically hazardous heavy metals. You are legally obliged to dispose of power
packs and batteries at the point of sale or in the corresponding containers provided at
collection points provided by local public waste authorities. Disposal is free of charge.
The adjacent symbols indicate that the batteries must not be disposed of in normal
domestic waste and must be brought to collection points provided by local public
waste authorities.
Packaging materials must be disposed of according to local regulations.
Helpline
Should problems arise with the device, please refer to the following information first.
In the case of technical problems, contact our Hotline. Please refer to our website
www.watch-and-care.com for the telephone number.
In the case of claims under the terms of guarantee, contact your sales outlet.
There is a 2 year period of guarantee.
Troubleshooting guide - Problems and solutions
Equipment does not function
• Transmitter and/or receiver are not switched on.
• The batteries are empty or defective.
• The power adapter plugs are not connected.
No reception
• Transmitter and receiver are not registered.
• The receiver and transmitter are too far apart.
• The sensitivity is set too low.
Reception interference
• The receiver and transmitter are too far apart.
• The battery power is too low.
• Other electronic devices are causing interference in the field of transmission.
GB
11