AUDIOLINE Watch & Care V161 Mode D'emploi page 10

Starting Up
Starting Up
a
Important: please make sure you've read the safety information on page 10 before you set up
your system.The data transmitted (image and/or sound) are digitally coded.
The Baby unit can be powered up using the power adaptor provided or using 4 AA batteries (not supplied).
Even if the power adaptor is used, we recommend that you also install batteries to guarantee continual
operation in the case of a power cut. Battery condition should be checked weekly to ensure leakage does not
occur.
1. Install 4 AA batteries (not supplied) into the battery compartment as shown observing the polarity markings
inside. Then replace the battery compartment cover.
Removing the batteries
When you need to remove the batteries, unplug the power adaptor and then open the battery compartment
cover and use the ribbon to gently pull them out.
1. Plug the power adaptor cable into the socked on the side of the Baby unit and plug the other end into the
mains power and switch on.
Connecting and aligning the transmitter
a
Attention: Position the transmitter with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance. We recommend you place the Baby unit between 1-2
metres away from your baby for best performance. Make sure the unit and cable is out of reach of
your baby.
Operating range
The operating range is up to 300 metres outdoors and 50 metres indoors. The actual operating range may vary
depending on the environmental conditions and other interferences such as walls, doors and other
obstructions. For best results, place the antenna upright.
The Baby unit may not detect sounds when the sensitivity level is set below a certain level so you may wish to
increase the sensitivity level, see page . You may also need to turn the loudspeaker volume up on the Parent
unit to hear the sounds transmitted from the Baby unit, see page .
Wall mounting the Baby unit – optional
The Baby unit is ready for tabletop use but you can wall mount it using the wall mounting bracket supplied if
you wish to. Make sure you test the units from the proposed position before wall mounting.
a
Important Before you wall mount, please check that:
• the wall can support the weight of the product
• the power adaptor will reach the power socket
• you are not drilling into any hidden wiring or plumbing
1.
Ð
Ð
8
2. 3.